Set opening time / Duration of active output

[Jantar]

The default time is set to 0.5sec. That means that when a finger is approached, the output is active for 0.5sec.

Set the duration of active output:
Connect the Button to the power supply. After the first beep and before the red LED lights, touch and hold the button. After two double beeps, remove your hand from the button. After 3 seconds the device will start to beep every two seconds. Each beep indicates half second of active output. Maximum time is five seconds. When you hear the required number of beeps, touch the button – the time is set.

Set toggle mode:
Connect the Button to the power supply. After the first beep and before the red LED lights, touch and hold the button. After two double beeps, remove your hand from the button. After 3 seconds the device will start to beep every two seconds. When beeping stops (after nine beeps), toggle mode is selected. Toggle mode means, if user card or code is registered, output will remain opened (if it was closed) or closed (if it was open) till next registration.